What we fix
Peeling, hot tire marks, fading, chips and cracks.
How
Find the cause, remove failed areas, prep and recoat.
Can you match my existing floor?
Close, though a full recoat blends best.
Do you remove old paint?
Yes.
Golf cart wear
Cart tires turning in the same spot every day wear a coating. We recoat those areas and add extra topcoat build.
Fading by the door
Older epoxy that was not UV stable fades and yellows near the door. A new UV-stable topcoat fixes it.
Finding the cause
Is it lifting at the door from water, along a crack from slab movement or in tire paths from poor bond? Each has a different fix, and we explain it.
Low-odor repairs
For occupied homes, we use low-odor repair materials so you do not need to leave.
Common repairs in Hemet
Epoxy floor repair in Hemet usually involves coatings that faded and chalked near the garage door from sun exposure, thin coatings worn through by golf cart traffic, and older floors peeling under hot tires. We also see painted floors that have flaked and need to be removed before a proper coating goes down.
Our repair process
We test bond strength, mark loose areas and decide whether a patch or full redo is the better choice. Patches get cut back to solid coating, ground and rebuilt. Sun-faded areas can get a new UV-stable topcoat.
Questions about repair
Can you repair a floor in a 55-plus community? Yes, and we follow community rules for noise and work hours.
How long does a repair take? Usually one to two days.
Will the smell bother me? We use low-odor products where possible.
Can old paint be removed? Yes, we grind it off before recoating.
When a full redo makes more sense
If the coating lifts easily in many places, patching only buys a little time. Grinding the whole floor and starting fresh costs more up front but ends the cycle of repairs. We show you what we found during testing so you can decide with the facts in hand, and we put both options in writing.
Preventing sun fade
A UV-stable topcoat near the garage door keeps the color from chalking where afternoon sun hits the floor every day. It is a simple upgrade during any repair.
Sun fade and peeling at the garage door
The most common repair call we get in Hemet is about the first few feet inside the garage door. That strip gets the most sun, the most heat from car tires, and the most grit blown in by wind. On older coatings, especially store-bought kits or thin epoxy without a UV-stable topcoat, that area fades, turns yellow or starts to peel, while the rest of the floor still looks fine.
A good repair starts by finding the edge of sound coating. We test adhesion, grind away anything loose and feather the edges so the patch blends into the remaining floor. Then we rebuild with base coat and, if your floor has flake, a matching or complementary chip blend, and finish with a UV-stable clear coat across the whole repair area.
Matching an old floor
Exact color matches are hard on a floor that has aged for years. Where a perfect match is not possible, we may suggest a contrasting border at the door or recoating the full floor with a new clear coat so the color looks consistent.
Other common repairs
We also fix chips from dropped tools, gouges from moving furniture, and areas lifted by moisture from below. Moisture problems need more than a patch, so we test the slab and may recommend a moisture-mitigating primer in the repaired area.
Can you fix a floor another contractor installed? Usually yes, once we understand what system was used.
Will the repair be visible? Possibly a little, depending on age and color. We show you samples before starting.
After any repair we walk you through simple care: rinse grit away from the door area, wipe up brake fluid and gasoline spills quickly, and use a mat where tires sit. Small habits like these keep the repaired section looking like the rest of the floor.
Get a repair estimate
Call (951) 669-2681.